Overhead Garage Door Repair in Denver, CO
Overhead sectional doors fail in predictable ways — worn rollers, stretched cables, bent tracks, dead openers. We diagnose the actual cause on-site instead of upselling a full door replacement, and most repairs finish in one visit.
Typical pricing
Most overhead door repairs in Denver: $145–$425 depending on parts. Roller sets, single cable, and track straightening fall in the lower range; cable + drum + bearing combos in the upper.
Response time
Same-day in Denver, Aurora, Lakewood, Centennial, Arvada, Thornton. Often within 2–3 hours.
Symptoms we see
- Door binds or grinds halfway up or down
- Visible gap between roller and track
- Cable hanging loose on one side
- Door slams shut instead of lowering smoothly
- Opener runs but door doesn't move
Common causes in Denver
Worn steel rollers
Builder-grade steel rollers last 5–7 years before the bearings seize. Once one binds, the door pulls sideways and starts wearing the track.
Stretched or frayed lift cables
Cables stretch every cycle and frayed strands snag inside the drum. A snapped cable lets the door free-fall — replace at the first sign of fray.
Bent or misaligned tracks
A bumper tap or a heavy snow load bends vertical track flanges. Straightening works for minor bends; replacement is required when the radius is deformed.
How we fix it
- Step 1
Full overhead inspection
Springs, cables, drums, rollers, hinges, tracks, opener — 25 points checked before we quote.
- Step 2
Repair, not replace
We fix what's broken. We'll only recommend a new door if panels are cracked or the section count is wrong for the opening.
- Step 3
Balance and lube
Door should hold position at the halfway mark with one hand. We tune spring tension until it does.
- Step 4
Safety test
Photo-eye alignment, auto-reverse force test, and opener limit check before we leave.
FAQ
Can you repair commercial overhead doors?
Yes — light commercial sectional doors up to 12 feet tall. For high-cycle rolling steel or fire doors over 12 feet, we'll refer you to a commercial-only specialist.
How long does a typical overhead door repair take?
Roller swap, cable replacement, or track straightening: 60–90 minutes on-site. Full opener replacement: about 2 hours.
Do you carry parts on the truck?
Yes — rollers, cables, hinges, bearings, drums, weatherstrip, and the most common torsion springs. About 95% of overhead repair calls finish in one visit.
Is repair worth it on an older door?
If the panels are straight and uncracked, repair is almost always cheaper than replacement. We'll tell you honestly when a door has reached end of life.
Do you warranty repairs?
Parts carry the manufacturer warranty (1–7 years depending on the part). Our labor is warrantied for 1 year on any repair.
Need help in Denver right now?
Same-day dispatch across the metro. Call us or send a quick message and we'll respond within the hour during business hours.